Sony SDM-N80 User Manual download pdf (Page 22)

D:\SDM\n80\N80GB\001009\3868361251\386836125SDMN50AEP\02GB-

SDMN50AEP\01GB02BAS-AEP.fm

masterpage:Left

SDM-N80

4-082-671-12(1)

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the

following messages appears on the screen. To solve the problem,

see “Trouble symptoms and remedies” on page 23.

If OUT OF SCAN RANGE appears on the screen

This indicates that the input signal is not supported by the

monitor’s specifications. Check the following items.

If “xxx.x kHz / xx Hz” is displayed

This indicates that either the horizontal or vertical frequency

is not supported by the monitor’sspecifications.

The figures indicate the horizontal and vertical frequencies of

the current input signal.

If “RESOLUTION > UXGA” is displayed

This indicates that the resolution is not supported by the

monitor’s specifications.

If NO INPUT SIGNAL appears on the screen

This indicates that no signal is being input from the currently

selected connector.

INPUT:

This indicates the currently selected connector (INPUT: 1 or

INPUT: 2).

If “GO TO POWER SAVE” is displayed

When the POWER SAVE menu is set to ON, the monitor

enters the power saving mode after about 4 seconds from the

time the message is displayed.

If “USB CONNECTED” is displayed

This indicates that a computer whose power is on is connected

to the USB upstream connector on the monitor. For that

reason, the monitor willnot enterthe power savingmode even

if the POWER SAVE menu is set to ON.

If PLEASE CHANGE TO SXGA appears on the

screen

This indicates that the resolution of the input signal exceeds

1280 × 1024 (SXGA). Set your computer to output a signal

1280 × 1024.

If CABLE DISCONNECTED appears on the screen

This indicates that the video signal cable has been

disconnected from the currently selected connector.

INPUT:

This indicates the currently selected connector (INPUT: 1 or

INPUT: 2).

If “GO TO POWER SAVE” is displayed

When the POWER SAVE menu is set to ON, the monitor

enters the power saving mode after about 4 seconds from the

time the message is displayed.

If “USB CONNECTED” is displayed

This indicates that a computer whose power is on is connected

to the USB upstream connector on the monitor. For that

reason, the monitor will not enter the power saving mode even

if the POWER SAVE menu is set to ON.

OUT OF SCAN RANGE

xxx.xkHz/ xxHz

INFORMATION

NO I NPUT S I GNAL

I NPUT : 1

GO TO POWER SAVE

INFORMATION

RESOLUT I ON > SXGA

PLEASE CHANGE TO SX AG

INFORMATION

CABLE D I SCONNECTED

INPUT:1

GO TO POWER SAVE

INFORMATION

01GB01COV-AEP.book Page 22 Monday, July 16, 2001 2:22 PM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 123 124

Comments to this Manuals

No comments

Sony SDM-N80 User Manual Page 22

Comments to this Manuals

Related products and manuals for TVs & monitors Sony SDM-N80