Sony KDL-46V25L1 User Manual download pdf (Page 7)

7 (GB)

SU-WL51

2-652-380-11(1)

Adjust the angle of the arms.

When installing the TV or monitor perpendicularly (0

degrees), adjustment of the arm angle (procedures 1

and 2 below) is not necessary. Make sure that each

arm base is screwed in securely.

1 Remove the screws from the top and bottom centre

of the both arm bases. Then choose the notch

corresponding to the desired angle (5, 10, 15 or 20

degrees) and fit each arm base to them.

If you are installing the KLV-40U100M, do not

choose the notch for 20 degrees.

2 Firmly secure each arm base using the screws

removed in the above procedure 1.

Notes

• Be sure to adjust the angles of the right and left arms to the

same angle.

• Be careful not to pinch your fingers when adjusting the

angle of the arms.

• When using an electric screwdriver, set the torque setting

to approximately 2 N·m {20 Kgf·cm}.

• Make sure that the two arm bases are screwed in securely.

Notes on the adjustment angles

• When installing TV or monitor models other than

those specified on page 2 (depending on the

model's size and dimensions, etc.), the adjustment

angles listed (0, 5, 10, 15, 20 degrees) for the arms

may be limited.

• For the available adjustment angles of the arms

when installing TV or monitor models other than

those specified on page 2, refer to the operating

instructions or the leaflet (“Installing the Wall-

Mount Bracket”) supplied with the TV or monitor.

• 0 degrees: Leave the white screws tightened as they are.

• Other than 0 degrees: Remove the white screws.

Arm base

Change the position of the

Mounting Hook Unit support

shafts.

1 Remove the screws securing the both left and right

Mounting Hook Unit support shafts, and then move

the Mounting Hook Unit support shafts to the inner

position. Make sure the marks on the both

Mounting Hook Unit support shafts align with the

F marks on the plate unit.

2 Secure the Mounting Hook Unit support shafts

using the screws from procedure 1.

Notes

• When using an electric screwdriver, set the torque

setting to approximately 2 N·m {20 Kgf·cm}.

• Make sure that the two Mounting Hook Unit support

shafts are screwed in securely.

Mounting Hook Unit

support shaft

01GB01COV.book Page 7 Tuesday, December 20, 2005 4:59 PM

1 2 3 4 5 6 7 8 9 10 11 12 ... 111 112

Comments to this Manuals

No comments

Sony KDL-46V25L1 User Manual Page 7

Comments to this Manuals

Related products and manuals for Televisions Sony KDL-46V25L1