Sony RM-VL610 User Manual download pdf (Page 21)

Continued

3 Press and hold the button

on the other remote control,

until the SET indicator

lights and all the

Component Select buttons

flash again.

During data transfer, only the

SET indicator stays lit, and the

Component Select button turns

off.

If the SET indicator flashes

five times

It means that “learning” is

incomplete. Repeat Steps 2 and 3.

4 Repeat Steps 2 and 3 to

“teach” remote control

signals to other buttons.

5 Press SET to finish

“learning.”

Notes

• If you do not perform Learning steps

within 20 seconds at any point during

the process, Learning mode ends.

• If you do not perform Step 3 within

10 seconds after Step 2, the Learning

procedure returns to Step 1. Repeat

from Step 2 while the Component

Select button is lit.

To cancel “learning,” press SET.

If another signal has already

been “learned” by that

button

The SET indicator flashes twice,

and the Commander takes no

action, returning to its state after

SET was pressed and held in Step 2.

Either “teach” to another free

button, or clear the already

“learned” function (page 22) and

start over from the beginning.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

No comments

Sony RM-VL610 User Manual Page 21