Sony PFM-42B2H User Manual Page 92

  • Download
  • Add to my manuals
  • Print
  • Page
    / 294
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 91
40 (GB)
The following menu appears on the display panel.
ENTER
MENU
POWER CONTROL
POWER SAV I NG : OFF
ON / OF F T I MER : OFF
SELECT SET END
ENERGY SAV I NG : OFF
PFM-42B1/42B1E: “ENERGY SAVING” is not displayed.
2 Press
v
/
V
to move the cursor (B) to “POWER
SAVING” and press ENTER.
The following menu appears on the display panel.
POWER SAV I NG : OFF
3 Press
v
/
V
to select the length of time until the
change to power saving mode.
OFF: The power saving function does not work.
5min: Changes to the power saving mode after
five minutes if there is no input signal.
10min: Changes to the power saving mode after
10 minutes if there is no input signal.
The ON indicator flashes when the unit is in the
power saving mode.
To cancel the power saving function
Input the sync signal again.
Press the 1 (standby) switch on the 1 (standby)
switch / indicator section or the POWER ON switch
on the Remote Commander.
Signal specification for using the power
saving function
The sync signal should be the RGB signal input to the
13th pin of the RGB/YUV (D-sub 15-pin) connector
in the INPUT 1 or INPUT 2 connectors.
On/Off Timer Function
1 In the CONFIG (1/2) menu, press v / V to move
the cursor (B) to “POWER CONTROL” and press
ENTER.
Controlling Power On/Off Automatically (Power Control Function)
ENTER
MENU
CONF I G ( 1 / 2 )
DISPLAY : ON
W-VGA : OFF
CLOSED CAPT ION: OFF
C OLOR SYSTEM:AUTO
SCREEN F I L L : CENTER
POWER CONTROL
SCREEN SAVER
SELECT SET END
YUV LEVEL : SMPTE
3 Press
v
/
V
to move the cursor (B) to “POWER
CONTROL” and press ENTER.
The following menu appears on the display panel.
ENTER
MENU
POWER CONTROL
POWER SAV I NG : OFF
ON / OF F T I MER : OFF
SELECT SET END
ENERGY SAV I NG : OFF
4 Press
v
/
V
to move the cursor (B) to “ENERGY
SAVING” and press ENTER.
The following menu appears on the display panel.
ENERGY SAV I NG : OFF
5 Press
v
/
V
to select the ENERGY SAVING
mode ON/OFF.
OFF: No energy saving
ON: Energy saving
By enabling the ENERGY SAVING (ON), the
screen brightness is reduced and you can view the
display unit while saving energy.
Power Saving Function
1 In the CONFIG (1/2) menu, press
v
/
V
to move
the cursor (B) to “POWER CONTROL” and press
ENTER.
Page view 91
1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 293 294

Comments to this Manuals

No comments