Sony WALKMAN MZ-NH1 User Manual Page 81

  • Download
  • Add to my manuals
  • Print
  • Page
    / 128
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 80
81
While recording
Symptom Cause/Remedy
The remaining
recording time appears
as “–0:00:00” and
recording cannot be
done, even though
2.0MB of free space is
displayed.
This is a system limitation. 2.0MB is the capacity of the reserve
domain.
The recorder always
creates a new group
when recording.
The group recording (“Group REC”) is set to “GroupREC On”.
(You cannot overwrite tracks.)
, Set the group recording setting to “GroupREC Off” (page 40).
The first few seconds of
a track cannot be
recorded.
If you start recording while the disc indication is rotating, data will
not be recorded to the first few seconds of the first track.
, Wait until the disc indication stops rotating before you start
recording.
Recording cannot be
done correctly.
Audio sources may not be securely connected.
, Disconnect the audio sources once and connect them again
(pages 20 and 36).
There is no digital signal from the portable CD player.
, When recording digitally from a portable CD player, use the
AC power adaptor and disable the anti-skip function (such as
ESP) on the CD player (page 24).
The analog recording was made using a connecting cord with an
attenuator.
, Use a connecting cord without an attenuator.
Recording level is too small to record (when adjusting the
recording level manually).
, Pause the recorder and adjust the recording level (page 38).
The recorder is connected to the computer.
, Disconnect the recorder from the computer when recording.
The power sources was disconnected or a power outage occurred
during recording.
, The recording result is not recorded on the disc. Make
recording again.
The premastered disc is inserted.
, Replace to the recordable disc.
Recording may not be done if the remaining recordable time on the
disc is 48 seconds or less (“DISC FULL” appears).
, Replace the disc.
Stereo sound is heard in
the headphones/
earphones while
recording in monaural.
This is normal. During digital recording, the sound will be stereo
in the headphones/earphones, even though the recorded sound is
monaural.
Momentary noise is
heard when recording.
Due to the special digital audio compression technology used in
LP4 stereo mode, momentary noise may occur on very rare
occasions with certain sound sources.
, Record in SP or LP2 mode.
Page view 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 127 128

Comments to this Manuals

No comments