Sony KD-55A1 User Manual download pdf (Page 3)

If your existing television set is being retained and relocated, the

same considerations as above should be applied.

Installation/Set-up

Install and use the TV set in accordance with the instructions

below in order to avoid any risk of fire, electric shock or damage

and/or injuries.

Installation

• The TV set should be installed near an easily accessible AC

power outlet (mains socket).

• Place the TV on a stable, level surface to prevent it from falling

over and causing personal injury or property damage.

• Install the TV where it cannot be pulled, pushed, or knocked

over.

• Install the TV so that the TV bottom does not protrude out from

the TV stand (not supplied). If the TV bottom protrudes out from

the TV stand, it may cause TV set to topple over, fall down, and

cause personal injury or damage to the TV.

• Only qualified service personnel should carry out wall-mount

installations.

• For safety reasons, it is strongly recommended that you use

Sony accessories, including:

 Wall-Mount Bracket SU-WL450

• Be sure to use the screws supplied with the Wall-Mount Bracket

when attaching the Wall-Mount Bracket to the TV set. The

supplied screws are designed as indicated by illustration when

measured from the attaching surface of the Wall-Mount Bracket.

The diameter and length of the screws differ depending on the

Wall-Mount Bracket model.

Use of screws other than those supplied may result in internal

damage to the TV set or cause it to fall, etc.

Transporting

• Before transporting the TV set, disconnect all cables.

• Two or three people are needed to transport a large TV set.

• When transporting the TV set by hand, hold it as shown below.

Do not put stress on the panel and the frame around the screen.

• When handling or mounting the

TV set, do not lay down the TV.

• When transporting the TV set, do not subject it to jolts or

excessive vibration.

• When transporting the TV set for repairs or when moving, pack

it using the original carton and packing material.

Topple prevention

Remove the center cover.

2 Secure the TV to the TV stand.

Sufficient expertise is required when installing the TV to the

Table-Top Stand.

Refer to the Setup Guide supplied with the TV for stand

installation.

Sony is not liable for any damage or injury caused by

mishandling or improper installation.

Screw (M6)

Wall-Mount Bracket

10 mm - 14 mm

TV’s rear cover

10 mm - 14 mm

M6 screw

(not supplied)

Screw (not supplied)

Cord (not

supplied)

1 2 3 4 5 6 7 8 ... 23 24

Comments to this Manuals

No comments

Sony KD-55A1 User Manual Page 3

Comments to this Manuals

Related products and manuals for LCD TVs Sony KD-55A1