Sony MHC-DX101 User Manual download pdf (Page 25)

25

Additional Information

Troubleshooting (continued)

Speakers

Sound comes from one channel or unbalanced

left and right volume.

• Check the speaker connection and speaker

placement.

Sound lacks bass.

• Check that the speaker’s + and – jacks are

connected correctly.

CD Player

The CD tray does not close.

• The CD is not placed properly.

The CD will not play.

• The CD is not lying flat in the disc tray.

• The CD is dirty.

• The CD is inserted label side down.

• There is moisture on the CD.

Play does not start from the first track.

• The player is in program or shuffle mode. Press

PLAY MODE repeatedly until “PROGRAM” or

“SHUFFLE” disappears.

Tape Deck

The tape does not record.

• No tape in the cassette holder.

• The tab has been removed from the cassette (see

“To save a tape permanently” on page 23).

• The tape has reeled to the end.

The tape does not record nor play or there is a

decrease in sound level.

• The heads are dirty (see “Cleaning the tape

heads” on page 23).

• The record/playback heads are magnetized (see

“Demagnetizing the tape heads” on page 23).

The tape does not erase completely.

• The record/playback heads are magnetized (see

“Demagnetizing the tape heads” on page 23).

There is excessive wow or flutter, or the sound

drops out.

• The capstans or pinch rollers are dirty (see

“Cleaning the tape heads” on page 23).

Noise increases or the high frequencies are

erased.

• The record/playback heads are magnetized (see

“Demagnetizing the tape heads” on page 23).

Tuner

There is severe hum or noise (“TUNED” or

“STEREO” flashes in the display).

• Adjust the antenna.

• The signal strength is too weak. Connect the

external antenna.

A stereo FM program cannot be received in

stereo.

• Press STEREO/MONO so that “STEREO”

appears.

If other troubles not described above

occur, reset the system as follows:

1 Unplug the power cord.

2 Plug the power cord back in.

3 Press x, ENTER, and ?/1 at the same

time.

4 Press ?/1 to turn on the system.

The system is reset to the factory settings. All

the settings you made are cleared.

Messages

One of the following messages may appear or

flash in the display during operation.

NO DISC

• There is no CD on the disc tray.

OVER

• You have reached the end of the CD.

1 2 ... 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments