Sony MDS-JE480 User Manual download pdf (Page 8)

masterpage:Left

(3 column)

filename[D:\Data Folder\sem\4238553111MDSJE480CEL\GB05OPE-CEL.fm]

8

GB

model name1[MDS-JE480]

[4-238-553-11(1)]

Recording to MDs

If the MD has been partially recorded,

recording starts after the recorded tracks.

1

Turn on the amplifier and program

source, and select the source on the

amplifier.

2

Press ?/1 to turn on the deck.

The STANDBY indicator turns off.

3

Load a recordable MD into the slot

(page 15).

4

Press INPUT repeatedly to select the

input jacks (connector) connected to

the program source.

5

Press REC z.

The deck changes to recording pause.

6

Adjust the recording level if necessary.

For details, see “Adjusting the recording

level” on page 12.

7

Press H or X.

Recording starts.

8

Start playing the program source.

Operations you may want to do

during recording

1) The track number increases by one.

Recording to an MD

When the source is

connected to the

Set INPUT to

DIGITAL OPTICAL IN

connector

D-IN

ANALOG IN jacks A-IN

To Press

Stop recording x

Pause recording X

Resume recording after

pausing

1)

H or X

Eject the MD EJECT A after stopping

recording

To change the display while

recording

Press LEVEL/DISPLAY/CHAR (or DISPLAY)

repeatedly to change the display.

Each time you press the button, the display

changes cyclically as follows:

Track number and recorded time of the current

track t Remaining recordable time

2)

on the

MD t Level of the input signal t Track

name

3)

2) Time shown in the display differs depending on

the setting of REC MODE.

3) “No Name” appears when the track has no name.

After recording

Press EJECT A to remove the MD or press

?/1 to turn off the deck.

“TOC” or “TOC Writing” starts flashing. The

TOC is updated and recording is completed.

Before disconnecting the AC power

cord

MD recording is completed when the MD Table

of Contents (TOC) is updated. The TOC is

updated when you eject the MD or press ?/1 to

turn off the deck. Do not disconnect the AC

power cord before updating the TOC (while

“TOC” is lit) or while updating the TOC (while

“TOC Writing” is flashing) to ensure a

complete recording.

Automatic conversion of digital

sampling rates

A built-in sampling rate converter automatically

converts the sampling frequency of various

digital sources to the 44.1 kHz sampling rate of

the MD deck. This allows you to monitor and

record sources such as 32 or 48 kHz DAT tape

or satellite broadcasts, as well as the CDs and

MDs.

Notes on recording

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Comments to this Manuals

No comments