Sony XBA-1iP User Manual Page 1

Browse online or download User Manual for Headphones Sony XBA-1iP. Sony XBA-1iP User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Stereo Headset
Operating Instructions
Manual de instrucciones
4-408-899-11(1)
©2011 Sony Corporation
Printed in Thailand
XBA-1iP
Frequency response: 5 Hz – 25,000 Hz
Cord: 1.2 m (47
1
/4 in) (Y-type)
Plug: Four-conductor gold-plated L-shaped stereo
mini plug for iPod with remote function
Mass: Approx. 3 g (0.11 oz) (without cord)
Microphone
Open circuit voltage level: – 42 dB (0 dB=1 V/Pa)
Supplied accessories
Hybrid silicone rubber earbuds: SS (red) (2), S (orange)
(2), M (green) (attached to the unit at the factory) (2),
L (light blue) (2) / Noise isolation earbuds: S (orange)
(2), M (green) (2), L (light blue) (2) / Cord adjuster
(winds cord up to 50 cm (19
3
/4 in)) (1) / Clip (1) /
Carrying pouch (1)
* IEC = International Electrotechnical Commission
** 150 mV input
Design and specifications are subject to change without
notice.
Optional replacement earbuds can be ordered from
your nearest authorized Sony retailer or www.sony.
com.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
About noise isolation earbuds
Supplied noise isolation earbuds provide a snug fit for
effective attenuation of ambient noise.
Notes
Prolonged use of snugly fitting earbuds may strain
your ears. If you experience discomfort, discontinue
use.
The pressure-relieving urethane cushion is extremely
soft. If it breaks or detaches from the earbuds, it will
not take its correct position and the earbuds will lose
their noise isolation function.
The urethane cushion may deteriorate over time. If
the pressure-relieving power is lost and the urethane
cushion hardens, the earbuds may lose their noise
isolation function.
Do not wash the earbuds. Keep them dry, otherwise
they may deteriorate quickly.
About hybrid silicone rubber earbuds
Keep earbuds clean. To clean the earbuds, wash them
with a mild detergent solution.
Removing the headphones
After use, remove the headphones slowly.
Note
Headphones are designed to fit closely in your ears. If the
headphones are pressed hard while in use or taken off too
quickly, they may cause injury.
Wearing headphones may produce a diaphragm click
sound. This is not a malfunction.
Precautions
High volume may affect your hearing.
For traffic safety, do not use while
driving or cycling.
Install the earbuds firmly. If an earbud
accidentally detaches and is left in
your ear, it may cause injury.
Do not leave the stereo headphones in a location
subject to direct sunlight, heat or moisture.
Note on static electricity
Static electricity accumulated in the body may cause
mild tingling in your ears.
To minimise the effect, wear clothes made from natural
materials.
Using the Center button
Plays/pauses a track of the connected iPod product
with a single press. Skips to the next track with a double
press. Skips to the previous track with a triple press.
Starts the “VoiceOver*” feature with a long press (if
available).
Press once to answer the call. Press again to end. Hold
down for about two seconds to reject an incoming call.
When you let go, two low beeps confirm the call was
rejected.
* Availability of the “VoiceOver” feature depends on
iPod and its software version.
Note
Be careful not to unintentionally press any buttons
when you carry your iPod with this unit connected.
Features
Earbuds with remote controller for iPod/
iPhone/iPad
Easy-to-use remote control (only for iPod, iPhone
and iPad)
Newly developed Balanced Armature driver
unit
Newly developed micro-size driver unit (full-range)
reproduces smooth and clear vocal sound.
Newly developed Double Layered Housing
Liquid Crystal Polymer inner housing and special
ABS outer housing reproduce clear, distortion-free
mid-high range.
Noise-blocking design
Noise-blocking design attenuates ambient noise and
sound leakage.
Super-small body
Balanced Armature driver unit allows for a super
small body, and ultimate wearing comfort.
Specifications
Headphones
Type: Closed, Balanced Armature
Driver unit: Balanced Armature
Power handling capacity: 100 mW (IEC*)
Impedance: 24 Ω at 1 kHz
Sensitivity: 108 dB**
How to use Clip Earbuds
Hybrid silicone rubber earbuds Noise isolation earbuds
Volume +*
Center button
Volume 
Microphone
English Stereo headset
Compatible iPod/iPhone models
You can use the unit with only the following models
supporting remote control. Update your iPod, iPhone
or iPad to the latest software before use. In the
Operating Instructions, iPod, iPhone and iPad are
collectively described as “iPod” except in special cases.
iPod touch 4th generation
iPod touch 3rd generation
iPod touch 2nd generation
iPod nano 6th generation
iPod nano 5th generation (video camera)
iPod nano 4th generation (video)
iPod classic 120GB 160GB (2009)
iPod shuffle 4th generation
iPod shuffle 3rd generation
iPhone 4
iPhone 3GS
iPad 2
iPad
On copyright
iPhone
®
, iPod
®
, iPod classic
®
, iPod nano
®
, iPod
shuffle
®
, and iPod touch
®
are trademarks of Apple
Inc., registered in the U.S. and other countries. iPad
®
is
a trademark of Apple Inc.
“Made for iPod,” “Made for iPhone,” and “Made for
iPad” mean that an electronic accessory has been
designed to connect specifically to iPod, iPhone, or
iPad, respectively, and has been certified by the
developer to meet Apple performance standards. Apple
is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
* There is a tactile dot beside Volume +.
LM LMSSSS
Pressure-relieving
urethane cushion
Page view 0
1 2

Summary of Contents

Page 1 - Stereo Headset

Stereo HeadsetOperating InstructionsManual de instrucciones4-408-899-11(1)©2011 Sony Corporation Printed in ThailandXBA-1iPFrequency response: 5 Hz

Page 2

Stereo HeadsetOperating InstructionsManual de instruccionesXBA-1iPEspecificacionesAuricularesTipo: Cerrado, armadura balanceadaUnidad auricular: Armad

Comments to this Manuals

No comments