Sony HK-PSU01 User Manual

SIGNAL PROCESSING UNITPFV-SP3100BACKUP POWER SUPPLY UNITHK-PSU01INSTALLATION MANUAL1st EditionSerial No. 10001 and Higher (PFV-SP3100)Serial No. 10001

PFV-SP31001-6 (E)1-6. Rack MountingnInstall a ventilating fan in the rack to prevent the increasein the temperature inside a rack when multiple units

1-7 (E)PFV-SP3100nThe maximum depth of an adaptor is 750 mm.The minimum depth of an adaptor is 595 mm.3. Firmly lay the right and left adaptors in the

PFV-SP31001-8 (E)1-7. Matching Connector/CableWhen external cables are connected to the connectors on the PFV-SP3100 rear panel, the hardware listed b

2-1 (E)PFV-SP3100Section 2Service Overview2-1. Cleaning the FilterwBe sure to turn off the power switch and disconnect thepower cord from the outlet b

PFV-SP3100The material contained in this manual consists ofinformation that is the property of Sony Corporation.Sony Corporation expressly prohibits t

Printed in JapanSony Corporation 2002. 7 22B&P Company ©2002PFV-SP3100 (SY) J, E3-690-471-01

PFV-SP3100! WARNINGThis manual is intended for qualified service personnel only.To reduce the risk of electric shock, fire or injury, do not perform a

1 (E)PFV-SP3100Table of ContentsManual StructurePurpose of this manual ...

2 (E)PFV-SP3100Manual StructurePurpose of this manualThis manual is the installation manual of Signal Processing Unit PFV-SP3100 andits Backup Power S

1-1 (E)PFV-SP3100Section 1Installation1-1. Operating EnvironmentOperating temperature +5 dC to +40 dCPerformance temperature +10 dC to +35 dCHumidity

PFV-SP31001-2 (E)1-3. Installation Spacem. Do not block the ventilation holes of the unit.. Both of the front and rear sides must be at least 20 cm aw

1-3 (E)PFV-SP31001-4. Installing/Removing Optional PowerSupply UnitwBefore installing the backup power supply unit HK-PSU01in PFV-SP3100, set the powe

PFV-SP31001-4 (E)1-5. Installing Optional Board1-5. Installing Optional BoardThe optional board can be installed in any empty slot ofPFV-SP3100.When i

1-5 (E)PFV-SP3100Board leverMain board26. Reinstall the board retainer.7. Reinstall the front panel.nWhen removing the main board, turn the board leve