Sony RDR-HX780 Operations Instructions download pdf (Page 116)

116

, The recorder supports only MP3 audio,

Dolby Digital and MPEG audio for DivX

video files. Press AUDIO and select MP3

audio or MPEG audio.

No sound is output from the HDMI OUT

jack.

, Try the following: 1Turn the recorder off

and on again.

2Turn the connected

equipment off and on again.

3Disconnect

and then connect the HDMI cord again.

, The HDMI OUT jack is connected to a

DVI device (DVI jacks do not accept audio

signals).

, The equipment connected to the HDMI

OUT jack does not conform to the audio

signal format. In this case, set “Audio

Output” to “PCM” in the “HDMI Output”

setup (page 112).

Sound distortion occurs.

, Set “Tuner Level” in the “Audio In” setup

to “Compression” (page 104).

Sound is noisy.

, When playing a CD with DTS sound

tracks, noise will come from the LINE

OUT R-AUDIO-L jacks (page 50).

The sound volume is low.

, The sound volume is low on some DVDs.

The sound volume may improve if you set

“Audio DRC” in the “Audio Out” setup to

“On” (page 106).

, Set “Tuner Level” in the “Audio In” setup

to “Normal” (page 104).

An alternate audio track cannot be

recorded or played.

, When recording from connected

equipment, set “External Audio” to

“Bilingual” in the “Audio In” setup

(page 104).

, Multilingual tracks (main and sub) cannot

be recorded on the HDD (when Video

Mode On), DVD+RWs, DVD-RWs

(Video mode), DVD+Rs, or DVD-Rs

(Video mode). To record the language, set

“Bilingual Recording” in the “Audio In”

setup to “A/L” or “B/R” before recording

(page 104). To record both the main and

sub sounds on a disc, record on DVD-

RWs/DVD-Rs (VR mode). To record on

the HDD, set “HDD Recording Format” to

“Video Mode Off” in the “Recording”

setup (page 108).

, If you have connected an audio component

to the DIGITAL OUT (COAXIAL) jack

and want to change the audio track for the

HDD (when “HDD Recording Format” is

set to “Video Mode Off” in the

“Recording” setup (page 108))/DVD-

RWs/DVD-Rs (VR mode) during

playback, set “Dolby Digital Output” in

the “Audio Out” setup to

“Dolby Digital -> PCM” (page 105).

The programme position cannot be

changed from the programme position

you are recording.

, Set the TV’s input source to “TV.”

Recording does not start immediately

after you press z REC.

, Operate the recorder only after “LOAD,”

“FORMAT,” or “INFO WRITE”

disappears from the front panel display.

Nothing was recorded even though you

set the timer setting correctly.

, There was a power failure during

recording.

, The recorder’s internal clock stopped due

to a power failure that lasted for more than

1 hour. Reset the clock (page 97).

, The channel was disabled after the timer

recording was set. See “Manual CH

Setting” on page 99.

, Disconnect the AC power cord (mains

lead) from the mains, and connect it again.

, The programme contains copy protection

signals that restrict copying.

Recording/Timer recording/

Editing

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 135 136

Comments to this Manuals

No comments