Sony VPL-PX11 User Manual download pdf (Page 20)

20 (GB)

To get the clearest picture

You can get the best picture automatically when a

signal from the computer is input. Press the APA key.

The picture is automatically adjusted to project the

clearest picture possible.

Notes

•Adjust the signal when a still picture is displayed on

the screen.

• Press the APA key when the full image is displayed

on the screen. If there are black edges around the

image, the APA function will not function properly

and the image may extend beyond the screen.

• If you switch the input signal or re-connect a

computer, press the APA key again to get the

suitable picture.

•“ADJUSTING” appears on the screen. To restore the

original screen, press the APA key again during the

adjustment.

•“Complete!” appears on the screen when the picture

is adjusted properly. However, depending on the

kinds of input signal, the picture may not always be

adjusted properly.

•Adjust the items in the INPUT SETTING menu

when you adjust the picture manually.

For details on the INPUT SETTING menu, see page 24

(GB).

To correct trapezoidal distortion

When the projected image is a trapezoid, correct it by

pressing the D KEYSTONE key on the Remote

Commander or by adjusting DIGIT KEYSTONE in

the INSTALL SETTING menu.

When the base edge is longer than the upper

edge as shown in the figure below:

When the upper edge is longer than the base

edge as shown in the figure below:

For details on “DIGIT KEYSTONE,” see page 28 (GB).

Set the value to negative.

Set the value to positive.

Projecting

To turn off the power

1 Press the I /

key.

“Power OFF?” appears on the screen.

Note

The message will disappear if you press any key

except the I /

key, or if you do not press any

key for five seconds.

2 Press the I /

key again.

The ON/STANDBY indicator flashes in green and

the fan continues to run for about 90 seconds to

reduce internal heat build-up. Also, the ON/

STANDBY indicator flashes quickly for the first

60 seconds. During this first 60 seconds, you will

not be able to turn the power back on with the

I /

key.

3 Unplug the AC power cord from the wall outlet

after the ON/STANDBY indicator lights in red.

Note

The built-in circuits provided for carrying out the

Off & Go function (page 8 (GB)) may keep the

cooling fan running for a while after the ON/

STANDBY indicator turns from green to red just

after you turn off the projector by pressing the

I /

key.

When you cannot confirm the on-screen

message

When you cannot confirm the on-screen message at

anytime, you can turn off the power by holding the

I /

key for about one second.

When you want to turn off the projector

quickly

You can also disconnect the power cord without

pressing I /

key. The cooling fan keeps running

automatically due to built-in circuits for a certain

period of time even though you unplug the power cord

(Off & Go function).

However, if the projector has not been turned on for a

long enough time, the cooling fan may not turn since

the projector’s condenser has not sufficiently charged.

If you do not use the Off & Go function

Unplug the AC power cord according to the procedure

described in “To turn off the power.”

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 111 112

Comments to this Manuals

No comments

Sony VPL-PX11 User Manual Page 20

Comments to this Manuals

Related products and manuals for Data projectors Sony VPL-PX11