Sony MHC-W55 User Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
For Your Information
26
In case color irregularity is observed
on nearby TV screen
With the magnetically shielded type of
speaker system, the speakers can be
installed near a TV set. However, color
irregularity may still be observed on the TV
screen depending on the type of your TV
set.
If color irregularity is observed...
Turn off the TV set once, then turn it on
after 15 to 30 minutes.
If color irregularity is observed
again...
Place the speakers farther away from the
TV set.
Troubleshooting
Guide
If you run into any problem using this
stereo system, use the following check list.
And first check the following points:
The power cord is connected firmly.
The speakers are connected correctly and
firmly.
Should any problem persist after you have
made the checks below, consult your
nearest Sony dealer.
Tuner
“TUNED” flashes in the display.
Adjust the aerial.
“STEREO” flashes in the display.
Adjust the aerial.
Severe hum or noise.
Adjust the aerial.
The signal strength is too weak.
Connect the external aerial.
Connect the ground wire.
A stereo FM program cannot be
received in stereo.
Press MONO so that “STEREO”
appears.
Tape Player
The tape does not record.
No tape in the cassette holder.
The tab has been removed from the
cassette.
The tape has reeled to the end.
Precautions
If you have any questions or problems
concerning your stereo system, please
consult your nearest Sony dealer.
On safety
The unit is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the
unit itself has been turned off.
Unplug the system from the AC power
outlet if it is not to be used for an
extended period of time. To disconnect
the AC power cord, pull it out by the
plug. Never pull the cord itself.
Should any solid object or liquid fall into
the component, unplug the stereo system
and have the component checked by
qualified personnel before operating it
any further.
AC power cord must be changed only at
the qualified service shop.
On installation
Place the stereo system in a location with
adequate ventilation to prevent heat build-
up in the stereo system.
On condensation in the CD player
component
If the system is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense on the
lens inside the CD player. Should this
occur, the CD player will not operate.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
To save a tape permanently
To prevent a tape from being accidentally
recorded over, break off the cassette tab
from side A or B as illustrated. If you later
want to reuse the tape for recording, cover
the broken tab with adhesive tape.
When you are using a TYPE II (CrO2) or
TYPE IV (metal) cassette, be careful not to
cover the detector slots which allow the
tape player to automatically detect the type
of tape.
Detector slots
For Your
Information
Precautions
Troubleshooting Guide
Maintenance
Specifications
Index to Parts and
Controls
Index
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments