Sony PDWF800 Specifications Page 250

  • Download
  • Add to my manuals
  • Print
  • Page
    / 295
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 249
FTP File Operations
250
Chapter 8 File Operations
MENU ON/OFF switch: OFF
Unsaved current clip list: Save or clear
Note
Login is not possible unless the unit is in the state
described above.
2 Start the command prompt.
3 Enter “ftp <SP> <IP address>”, and
press the Enter key. (<SP> refers to a
space.)
For example, if the IP address of this unit is
set to 192.168.001.010, enter “ftp
192.168.1.10”.
Refer to the Windows help for more information
about the FTP command.
If the connection succeeds, you are prompted
to enter a user name.
4 Enter the user name “admin” and press
the Enter key.
When the user name is verified, your are
prompted to enter a password.
5 Enter the password and press the Enter
key.
The password is set to the model name
(“pdw-f800” or “pdw-700”) when the unit is
shipped from the factory.
The login is complete when the password is
verified.
See “Command list” (page 250) for the protocol
supported by this unit.
If the connection times out
This unit terminates FTP connections if no
command is received within 90 seconds of
the last command. If this occurs, log out (see
the next section) and repeat steps 2 to 4.
Note
If you power this unit off during an FTP connection,
the data transferred thus far is discarded.
To log out
To log out after finishing file operations, enter
“QUIT” at the command prompt and press the
Enter key.
This unit supports standard protocol (see the next
section), and extended protocol (see page 253).
Notes
To execute FTP commands, you must install
application software such as PDZ-1 on your computer.
The commands supported by application software
vary.
An FTP client that supports UTF-8 is required to use
Unicode characters other than ASCII characters.
Command prompt FTP commands do not support
UTF-8.
Standard commands
In the command syntax column, <SP> means a
space, entered by pressing the space bar, and
<CRLF> means a new line, entered by pressing
the Enter key.
USER
Send this command to begin the login process.
Syntax: USER <SP> <username> <CRLF>
Input example: USER admin
PASS
After sending the USER command, send this command
to complete the login process.
Syntax: PASS <SP> <password> <CRLF>
Input example: PASS pdw-700
QUIT
Terminates the FTP connection. If a file is being
transferred, terminates after completion of the
transfer.
Syntax: QUIT <CRLF>
PORT
Specifies the IP address and port to which this unit
should connect for the next file transfer (for data transfer
from this unit).
Syntax: PORT <SP> <h1,h2,h3,h4,p1,p2>
<CRLF>
h1 (most significant byte) to h4 (least
significant byte): IP address
p1 (most significant byte), p2 (least
significant byte): Port address
Input example: PORT 10,0,0,1,242,48
(IP address: 10.0.0.1, Port number: 62000)
Command list
Page view 249
1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 294 295

Comments to this Manuals

No comments