Sony STR-DA3200ES User Manual download pdf (Page 47)

47

GB

Getting Started

•CODE 31

1

Press , then follow the instructions from step

1 of “Performing the auto calibration.”

•CODE 32, 33

1

When you press , “RETRY?” appears.

2 Press V/v to select “YES,” then press .

3 Follow the instructions from step 2 of

“Performing the auto calibration.”

4 Press V/v repeatedly to select preset number to

store preset settings then press .

When you select “WRN CHECK”

If a warning on the measurement result is

present, detailed information is displayed.

Press to return to step 1 of

“Confirming/saving the

measurement results.”

When you select “PHASE INFO”

You can check the phase of each speaker (in

phase/out of phase).

Press V/v repeatedly to select a

speaker, then press to return to

step 1 in “Confirming/saving the

measurement results.”

CODE 33 (SR) • Either the left or right surround

speakers is not connected.

• Surround back speakers are

connected even though

surround speakers are not

connected. Connect the

surround speaker to the

SURROUND terminal.

CODE 33 (SB) The surround back speaker is

connected only to the

SURROUND BACK

SPEAKERS R terminal. When

you connect only one surround

back speaker, connect it to the

SURROUND BACK

SPEAKERS L terminal.

Warning code Explanation

WARNING 40 The auto calibration has

completed. However, the noise

level is high. You may be able to

perform the auto calibration

properly if you try it again, even

though the measurement cannot

be performed in all environments.

Try to perform the auto

calibration in a quiet

environment.

Error code Cause and remedies

WARNING 41 The sound input from the

optimizer microphone is outside

the acceptable range. It is louder

than the loudest sound that can be

measured. Try to perform the auto

calibration when the environment

is quiet enough to allow proper

measurement.

WARNING 42 The volume of the receiver is out

of the acceptable range. Try to

perform the auto calibration when

the environment is quiet enough

to allow proper measurement.

WARNING 43 The distance and position of a sub

woofer cannot be detected. Or the

angle of the speaker position

cannot be detected. This may be

caused by noise. Try to perform

the auto calibration in a quiet

environment.

NO WARNING There is no warning information.

Warning code Explanation

continued

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 262 263

Comments to this Manuals

No comments