Sony STR-DA2800ES User Manual download pdf (Page 125)

125

US

Additional Information

• Audio input signals via the HDMI IN jacks

cannot be recorded.

• Check the connection of the recording

deck according to the audio signals you

want to record. Analog input signals can

be output only from the analog output

jacks.

A test tone is not output from the

speakers.

• The speaker cords may not be connected

securely. Check to see if they are

connected securely and cannot be

disconnected by pulling on them slightly.

• The speaker cords may have the short-

circuit problem.

A test tone is output from a different

speaker than the speaker displayed on

the screen.

• The speaker configuration set up is

incorrect. Make sure that the speaker

connections and the configuration match

correctly.

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM

antenna (aerial) as shown below.

Radio stations cannot be tuned in.

• Check that the antennas (aerials) are

connected securely. Adjust the antennas

(aerials) and connect an external antenna

(aerial), if necessary.

• The signal strength of the stations is too

weak with automatic tuning. Use direct

tuning.

• No stations have been preset or the preset

stations have been cleared (when tuning by

scanning preset stations is used). Preset the

stations (page 57).

• Press DISPLAY MODE on the receiver so

that the frequency appears on the display

window.

The USB device is not recognized.

• Turn off the receiver, then disconnect the

USB device. Turn on the receiver again

and reconnect the USB device.

• Connect the supported USB device.

• The USB device does not work properly.

Refer to the USB device operating

instruction on how to deal with this

problem.

Content on the USB device is not

displayed.

• The hierarchy of folders has exceeded 4

levels. The receiver can display content in

only up to 4 levels (including the “ROOT”

folder). However, folders in a 4th level

folder are not displayed.

No sound is output.

• Turn off the receiver, then disconnect the

USB device. Turn on the receiver again

and reconnect the USB device.

• Connect the supported USB device.

• Press N to start playback.

• When “2ch Analog Direct” is being used,

the sound is not output. Use other sound

field (page 59).

• The music data itself contains noise, or the

sound is distorted.

• Depending on the file format, there may be

files that sometimes cannot be played

back. For details, see “Network/USB”

(page 22).

Tuner

Receiver

Outdoor FM antenna (aerial)

USB device

continued

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 277 278

Comments to this Manuals

No comments