Sony MDS-JA3ES User Manual download pdf (Page 30)

Additional Information

The deck does not record.

^The \fb is record-protected ("Protected" appears).

Close the record-protect slot (see page 5).

^The deck is not connected properly to the sotmd

source. Make connections properly to the sound

source.

^The recording level is not adjusted properly (in case of

input through LINE IN). Turn REC LEVEL to adjust

the recording level properly (see page 12).

premastered MD is inserted. Replace it with a

recordable MD.

^There is not enough time left on the MD. Replace it

with another recordable MD with fewer recorded

tracks, or erase unnecessary tracks.

^There has been a power failure or the AC power cord

has been disconnected during recording. Data

recorded to that point may be lost. Repeat the

recording procedure.

An incompletely inserted MD cannot be pulled out.

^The MD deck's self-lock system has gripped the MD.

Insert the MD completely, then press = EJECT.

The sound has a lot of static.

■^Strong magnetism from a television or a similar device

is interfering with operations. Move the deck away

from the source of strong magnetism.

Note

If the deck does not operate properly even after you've

attempted the prescribed remedies, turn off the power, then

reinsert the plug into the power outlet.

Inputs

Specifications

Jack type Input

impedance

Rated input Minimum

input

MIC

Phono jack 600 ohms 0.8 mVrms 0.2 mVrms

LINE IN Phono jacks 47 kilohms

500 mVrms 125 mVrms

DIGITAL IN

OPTICAL

Square Optical

optical wave

connector lenghth

jack 660 nm

— —

DIGITAL IN

COAXIAL

Phono jack 75 ohms 0.5 Vp-p, —

±20%

Outputs

Jack Rated output

type

Load impedance

PHONES

Stereo 28 mW

phone

jack

32 ohms

LINE OUT Phono 2 Vrms

jacks (at 50 kilohms)

Over 10 kilohms

DIGITAL

OUT

Square -18 dBm

optical

connector

jack

Wave length: 660 nm

General

Power requirements 120V AC, 60 Hz

Power consumption 22 W

Dimensions (approx) (w/h/d)

430 X 125 X 345 mm

(17 X 5 X13 ®/s in.) incl. projecting

parts

Mass (approx) 6.0 kg (13 lbs 4 oz)

MD deck section

System

Disc

Laser

Laser output power

Laser diode properties

Revolutions (CLV)

Error correction

Sampling frequency

Modulation system

Number of channels

Frequency response

Signal-to-noise ratio

Wow and flutter

MiniDisc digital audio system

MiniDisc

Semiconductor laser (X=780 nm)

Emission duration: continuous

Less than 44.6 gW*

• This output is the value measured at a

distance of 200 mm from the objective

lens surface on the optical pick-up

block with 7 mm aperture.

Material: GaAIAs

400 rpm to 900 rpm

Advanced Cross Interleave Reed

Solomon Code (ACIRC)

44.1 kHz

EFM (Eight-to-Fourteen Modulation)

2 stereo channels

5 to 20,000 Hz ±0.5 dB

Over 102 dB (during playback)

Below measurable limit

Supplied accessories

Audio connecting cords (2 phono plugs - 2 phono plugs) (2)

Remote commander (remote) RM-D2M (1)

Sony SUM-3 (NS) batteries (2)

Optional accessories

Recordable MDs: MDW-60 (60 min), MDW-74 (74 min)

Optical cable: PCX1-15A

Coaxial digital connecting cable: VMC-IOG

U.S. and foreign patents licensed from Dolby Laboratories

Licensing Corporation.

Design and specifications are subject to change without

notice.

1 2 ... 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments

Sony MDS-JA3ES User Manual Page 30

Comments to this Manuals

Related products and manuals for Audio Sony MDS-JA3ES