SIGNAL PROCESSING UNITPFV-SP3300BACKUP POWER SUPPLY UNITHK-PSU03INSTALLATION MANUAL1st EditionSerial No. 10001 and Higher (PFV-SP3300)Serial No. 10001
PFV-SP33001-6 (E)1-6. Rack MountingnInstall a ventilating fan in the rack to prevent the increasein the temperature inside a rack when multiple units
1-7 (E)PFV-SP3300nThe maximum depth of an adaptor is 750 mm.The minimum depth of an adaptor is 595 mm.3. Firmly lay the right and left adaptors in the
PFV-SP33001-8 (E)1-7. Matching Connector/CableWhen external cables are connected to the connectors on the PFV-SP3300 rear panel, the hardware listedbe
2-1 (E)PFV-SP3300Section 2Service Overview2-1. Cleaning the FilterwBe sure to turn off the power switch and disconnect thepower cord from the outlet b
PFV-SP3300The material contained in this manual consists ofinformation that is the property of Sony Corporation.Sony Corporation expressly prohibits t
Printed in JapanSony Corporation 2000. 8 22Communication System Solutions Network Company ©2000HK-PSU03 (SY)PFV-SP3300 (SY) J, E3-204-888-01
PFV-SP3300! WARNINGThis manual is intended for qualified service personnel only.To reduce the risk of electric shock, fire or injury, do not perform a
1(E)PFV-SP3300Table of ContentsManual StructurePurpose of this manual ...
2 (E)PFV-SP3300Manual StructurePurpose of this manualThis manual is the installation manual of Signal Processing Unit PFV-SP3300 andits Backup Power S
1-1 (E)PFV-SP3300Section 1Installation1-1. Operating EnvironmentOperating temperature +5 dC to +40 dCPerformance temperature +10 dC to +35 dCHumidity
PFV-SP33001-2 (E)1-3. Installation Spacem. Do not block the ventilation holes of the unit.. Both of the front and rear sides must be at least 20 cm aw
1-3 (E)PFV-SP33001-4. Installing/Removing Optional PowerSupply UnitwBefore installing the backup power supply unit HK-PSU03in PFV-SP3300, set the powe
PFV-SP33001-4 (E)4. Insert the main board fully into the slot along the boardguides and close the board lever in the directionindicated by arrow 1.5.
1-5 (E)PFV-SP3300Installing Connector Panel (Rear side)The connector panel must be installed to the slot whichcontains the main board.1. Remove the tw
Comments to this Manuals