Sony ICF-M88B User Manual

Browse online or download User Manual for Bicycle accessories Sony ICF-M88B. Sony ICF-M88B User manual [da]

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Battery Life (Approx. hours) (JEITA*)
When using FM AM
Sony alkaline size AA (LR6) 66 84
Sony size AA (R6) 23 31
* Measured by JEITA (Japan Electronics and Information Technology Industries
Association) standards.
The actual battery life may vary depending on circumstances of use.
Replace the batteries
When the batteries become weak, the sound may become weak or distorted, and
E” will flash in the display. After that, when the batteries are used up, "E"
will light up and clock time display appears. And then the cycle-computer
function will be stopped so that any button functions will not work. The Radio
function will be also turned off if it is on. If this happens, replace the batteries
with new ones.
After the batteries are replaced, press RADIO POWER, RESET, or install the
unit on the Mount. (“E” turn off in the display.)
Note on replacing the batteries
Do not take more than 5 minutes to replace the batteries, otherwise, the clock
setting will be initialized. Should that happen, reset the functions.
Notes on batteries
Do not charge the dry batteries.
Do not carry the dry batteries together with coins or other metallic objects. It
can generate heat if the positive and negative terminals of the batteries
accidentally come into contact with metallic objects.
•When you are not going to use the unit for a long time, remove the batteries to
avoid damage from battery leakage and corrosion.
Do not use different types of batteries at the same time.
•When you replace the batteries, replace all with new ones.
Installing the unit on the
bicycle
Install the Wheel Magnet
1 Remove the screw of the wheel magnet and open.
2 Attach the magnet between two spokes of the front wheel with the
head of the screw facing inward, and tighten the screw.
Install the Mount
1 Choose the appropriate rubber pads according to the diameter of the
handlebar and attach them.
Use one or two rubber pads depending on the diameter of the handlebar. You
can attach the Mount clamps without the rubber pads if not required.
The Mount clamps are adjustable. You can adjust the width of the clamps to
fit your handlebar.
2 Install the Mount on the rubber pads and secure with the 4 screws.
3 Wind the sensor cord around the break cable.
Note
Be sure to allow enough cord slack to ensure full movement and unhindered
operation of the handlebar, and not to wind it too loosely as this may interfere
with the unit’s operation.
Features
FM/AM PLL(phase locked loop) synthesized radio with built in cycle-computer
•New ergonomic design
•Water-resistant for all-weather use
15 station memory presets (10FM/5AM)
Easy Jog lever operation
Easy to see backlit LCD
Easy to install mounting kit included
FM SENS DX(Distance)/LOCAL switch
Precautions
Operate the unit only on 3 V DC with two size AA (R6) batteries.
•Avoid exposure to temperature extremes, direct sunlight, moisture, sand, dust or
mechanical shock. Never leave in a car parked under the sun.
•Avoid continuous exposure to direct sunlight or extremely high temperatures to
prevent possible damage to the display. The display will function normally
again in normal operating temperature.
Display switching may become slower in cold climates.
Should any solid object or liquid fall into the unit, remove the batteries and
have the unit checked by a qualified personnel before operating it any further.
•To clean the casing, use a soft cloth dampened with a mild detergent solution.
Since a strong magnet is used for the speaker. Keep away personal credit cards
using magnetic cording or spring-wound watches from the unit to prevent
possible damage from the magnet.
Cautions on Water-resistance
This unit is designed so that it can be used with slight exposure to rain, snow and
other forms of moisture, but there are several points on which caution should be
observed.
Do not allow it to come into contact with large amounts of water.
Do not immerse it in water.
If water should get on it or if it should fall into water, take it out immediately
and wipe it off with a dry cloth. To prevent the battery from corroding, wipe out
the interior of the battery compartment as follows:
Open or close the battery compartment with dry hands in a place without
exposure to any water.
–Wipe off the battery and the inside of the battery compartment. Give special
attention to the contacts so that no water remains on them.
Notes on the cycle-computer radio
•The user must obey all traffic laws when using the device.
•To check whether the local laws allow the use of the device.
In order to prevent dangerous condition, do not operate the device when
running the bicycle.
In order to prevent theft, take your device with you at all times.
In order to prevent dangerous condition, install the sensor cord properly so that
it will not get tangle by the tire.
If you have any questions or problems concerning your unit, please consult your
nearest Sony dealer.
The preset stations may be initialized, if a maintenance service is performed.
Please keep a copy of your settings in case you want to preset them again.
Specifications
Time display: 12-hour system
Frequency range:
Band Range Channel step
FM 87.5 - 108 MHz 0.1 MHz
AM 530 - 1 710 kHz 10 kHz
531 - 1 710 kHz 9 kHz
Speaker: Approx. 50 mm (2 inches) dia, 8
Power output: 80 mW (at 10% harmonic distortion)
Power requirements: 3V DC, two size AA (R6) batteries
Dimensions :
Approx. 166.8 × 70 × 95 mm (w/h/d) (6
5
8
× 2
7
8
× 3
3
4
inches) incl.
projecting parts and control.
Mass: Approx. 281.4 g (9.93 oz) incl. batteries / excl. accessories
Supplied accessories:
Mount with wheel sensor (1), Thick/Thin rubber pads (2 each),
Wheel magnet (1), Zip ties (5), Double-sided tape (1), Screws (2)
Design and specifications are subject to change without notice.
Installing the Batteries
1 Slide OPEN to open the battery compartment lid and install two
size AA (R6) batteries (not supplied) with correct polarity.
When the batteries are first installed, “AM 12:00” flashes in the display.
Once the current time is set, the flashing stops. (See “Setting the Clock.”)
*Packing inside of the lid is used to ensure water-resistance for the battery
compartment. Therefore, make sure to close the battery compartment lid
securely.
2 Close the lid.
O
P
E
N
Operating Instructions
3-267-406-12(1)
FM/AM PLL Synthesized Radio
© 2004 Sony Corporation Printed in China
ICF-M88B
OWNER’S RECORD
The model number is located on the left side of the front panel, and the serial
number is inside the battery compartment. Record the serial number in the space
provide below. Refer to these numbers whenever you call upon your Sony dealer
regarding this product.
Model No. ICF-M88B Serial No.
For customers who purchased this product in the USA
Please register this product on line at
http://www.sony.com/productregistration
Proper registration will enable us to send you periodic mailings about new
products, services, and other important announcements. Registering your
product will also allow us to contact you in the unlikely event that the
product needs adjustment or modification. Thank you.
WARNING
You are cautioned that any changes or modifications not expressly approved
in this manual could void your authority to operate this equipment.
INFORMATION
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
Printed on 100% recycled paper using
VOC (Volatile Organic Compound)-free
vegetable oil based ink.
OPEN
Insert the # side of the battery first.
Size AA (R6) × 2
Packing*
1
2
1
2
4 Temporarily attach the Sensor to a fork using the attached
Double-sided tape.
When attaching, align the center of the sensor and that of the magnet (triangle
mark).
Ensure a clearance not exceeding 4mm (except Sensor and Magnet touching)
between the Sensor and the Wheel magnet (when aligned).
Attach the unit on the Mount, and then check the reaction of the sensor by
revolving the wheel (See fig. “Install the unit”).
5 After determining the position of the Sensor, secure it with the zip
tie to front fork and cut any surplus. Install the Sensor cord with zip
ties such that it does not become tangled with the wheel.
Note
Be careful that the position of the Sensor does not shift when tightening the zip
tie.
Install the unit
Install the unit on the Mount, sliding from the front until it clicks into position.
B
A
N
D
/
S
E
T
T
U
N
E
M
O
D
E
E
N
T
E
R
/
S
E
L
E
C
T
RADIO POWER
L
IG
H
T
Remove the unit
Pull the unit forward while pushing down the lever.
B
A
N
D
/
S
E
T
T
U
N
E
M
O
D
E
E
N
T
E
R
/
S
E
L
E
C
T
RADIO POWER
LIG
H
T
1
2
Note
Ensure that the contact points between the Mount and the unit are clean for
proper operation.
Caution
For safe and proper use of the cycle-computer, check whether the Mount, the
sensor and its cord and the wheel magnet are set properly before riding.
4mm
Zip tie
Wheel magnet
Sensor
Wheel magnet
Thin rubber pads
Thick rubber pads
Mount with wheel sensor
Mount clamp
Screw
Mount
Sensor
cord
Page view 0
1 2

Summary of Contents

Page 1 - FM/AM PLL Synthesized Radio

Battery Life (Approx. hours) (JEITA*)When using FM AMSony alkaline size AA (LR6) 66 84Sony size AA (R6) 23 31* Measured by JEITA (Japan Electronics an

Page 2 - Deleting a Preset Station

RADIOPOWERLIGHTENTER/SELECTTUNEMODEBAND/SETBAND/SETTUNEMODERADIO POWERLIGHTENTER/SELECTMPHAMPMFMFREEZEPRESETMHzMPHkHzkm/h inchAMkm/hmileCLOCK ODO DI

Comments to this Manuals

No comments